CRU DataPort 3 Installationsanleitung PDF herunterladen

Rugged, Reliable, Mobile, Secure

1-800-260-9800 www.CRU-DataPort.com

DataPort 3 Installation Guide

Affordable removable hard drive enclosure.

Preparation for Installation

Note: To prevent data loss, read this manual before

installing or operating the DataPort 3. Before touching

any electrical equipment, ground yourself by touching

the metal part of your computer chassis. This discharges

static electricity and prevents any damage to your com-

puter. CRU is not responsible for static discharge damage.

Tools Required

Phillips screwdriver

Other Items that May Be Needed

Computer Users Manual.

HDD manual (to set slave/master jumper for IDE only.)

Serial ATA cable or IDE data cable.

Frame Installation

1. Identify the 5.25” half-height bay in which you plan

to mount the DataPort 3 frame assembly. Remove

any ﬁller plates that may be present.

2. If the drive bay requires mounting rails, install

one on each side of the frame. The mounting rails

should be provided with your computer system.

3. Slide the frame into the 5.25” bay of the PC case.

If needed, use the screws provided to secure the

frame assembly to the PC case with the frame’s side

mounting holes.

4. Locate the data cable and connect it to the appropri-

ate IDE or Serial ATA connector on the frame.

5. Locate an available 4-pin DC power cable from the

computer power supply and plug it into the power

receptacle on the frame.

The frame installation is now complete.

Mounting a Hard Drive in the Carrier

1. Remove the carrier top cover. The cover of the

DataPort 3 slides into place on the carrier without

any screws.

2. For IDE units:

a) Set Master/Slave jumper on drive before

placing drive in carrier.

b) Connect the DC power cable to the drive.

c) Connect the data cable in the carrier to the

drive.

2a. For Serial ATA units place the drive in the

carrier and connect the male connector on

the hard drive to the female connector on

the carrier.

3. Secure the drive in the carrier, using the four

screws provided to mount the drive. Position the

cables inside the carrier assembly so that they are

completely enclosed within the carrier.

4. Ensure that the lock of the DataPort 3 is in the

“open” (vertical) position. Slide the carrier into the

frame. Using thumb pressure, fully seat the carrier

in the frame, then lock the unit with the keylock.

1 2

DataPort 3 Installation Guide 1

Inhaltsverzeichnis

Seite 1 - DataPort 3 Installation Guide

Rugged, Reliable, Mobile, SecureTM1-800-260-9800 www.CRU-DataPort.comDataPort 3 Installation GuideAffordable removable hard drive enclosure.Preparatio

Seite 2

Rugged, Reliable, Mobile, SecureTM1-800-260-9800 www.CRU-DataPort.comYou have ﬁnished the installation and your DataPort 3 is ready to operate.Operati

Kommentare zu diesen Handbüchern

Keine Kommentare

CRU DataPort 3 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach HDD / SSD-Gehäuse CRU DataPort 3 herunter. CRU DataPort 3 Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für HDD / SSD-Gehäuse CRU DataPort 3